Average of 100 units ready to ship
with standard 2-3 day delivery. FMI builds a complete line of standard
portable hydraulic punches. Standard flange and web presses range from
30 to 275 tons. Standard railcar "sideframe" presses are rated at 64
tons. All presses contain replaceable bronze guide bushings and
replaceable die pockets to maximize service life. An extended overstroke
design helps prevent damage caused by bottoming out the ram under high
pressure. Franklin uses high quality industry standard tooling in all
our presses. Standard tooling shapes are round, square, rectangular, and
slotted. Shaped punches and dies are keyed to facilitate punch to die
alignment. Flats are used unless other desired configuration is
specified when ordering shaped dies.
Note: 1> Provisions for keyed
tooling standard 50-ton and up. 2> Special presses quoted upon request.
When considering a Franklin C-Frame
Portable Press, FMI strongly urges careful analysis of your specific
application. When properly applied, your press will provide years of
dependable service. The first step to sizing your new press is to know
the press tonnage requirements based on the material you will most often
be piercing. The following formula will give a force (in tons) estimate
using flat-faced punches/dies.
New Version 1.1.1
- Written by Rodney Vaughn
License Agreement – Please
read the following important information before continuing. If you do
not agree to these conditions, please do not download and/or use this
software. By downloading this program, you confirm your agreement in
this license.
- Freeware – First of all, the reasons why Tonnage Calculator
is free:
Franklin logo is
included for advertising and to prevent any competitors from using our
software.
- Limitations – Reverse Engineering is not allowed as
with nearly any software. You may copy this software as long as no
modifications are made (which we hope is not possible) AND is not sold
for profit or otherwise.
- Warranty – None whatsoever
- Liability - Because this is a simple one file
executable program, it is very stable and does not modify or add other
files to your computer. We believe the information from this software
to be accurate and do not believe any inaccuracies will be found using
this software. However, for legal purposes we must specify that under
no circumstances can the use of this software make anyone (including
Franklin) liable for any damages you might occur using this software or
using any information acquired using this software.
Installation and Operation –
Hydraulic Punch
